Virginia DMV CDL General Knowledge Practice Test 6
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. The coolant temperature gauge climbs above its normal range on a long grade. What is the correct response?
Show answer
Answer C: Stop when it is safe to do so and find the cause before going on
Rising coolant temperature signals a fault such as a lost belt, a leak or a blocked radiator, and continuing can turn a repair into a destroyed engine.
-
2. Why is a leak in the exhaust system especially dangerous in cold weather?
Show answer
Answer A: Carbon monoxide can build up inside a closed cab
In winter the windows are shut and the heater is running, so exhaust gas that escapes early can reach the driver and cause drowsiness or worse.
-
3. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
4. What does the commercial driver manual tell you to do with the parking brake when you leave your vehicle?
Show answer
Answer B: Apply the parking brake every time you leave the vehicle
The manual is explicit that the parking brake goes on whenever the driver leaves the vehicle, because once nobody is at the controls it is the only thing holding it.
-
5. What should you look for on the electrical wiring in the engine compartment?
Show answer
Answer A: Worn, frayed or cracked insulation and loose or corroded connections
Damaged insulation can short a circuit against the frame or engine, which can kill a lamp you depend on or start a fire.
-
6. You find one lug nut missing from a wheel that has ten studs. What should you do?
Show answer
Answer C: Treat it as a defect and have it repaired before the vehicle is driven
Every missing fastener loads the others more heavily, and wheel separations usually begin with one nut that nobody replaced.
-
7. Which lights should be used in fog, by day or by night?
Show answer
Answer A: Low beams and fog lights, together with the four-way flashers
High beam light bounces back off the water droplets and makes seeing worse, while low beams, fog lights and flashers help you see and help others see you.
-
8. At highway speed, looking 12 to 15 seconds ahead means looking about how far down the road?
Show answer
Answer B: About a quarter of a mile
Twelve to fifteen seconds of travel is roughly a quarter of a mile at highway speed, while the same amount of time is about one block in slow city traffic.
-
9. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
10. What color must the clearance and side marker lamps and reflectors at the front of a trailer be?
Show answer
Answer A: Amber
Amber marks the front and the forward part of the sides of a vehicle, while red marks the rear, so another driver can tell which way the vehicle is facing.
-
11. You are hauling a load of steel plate that is well within every weight limit but is stacked five feet high on a flatbed. What is the main concern?
Show answer
Answer A: The center of gravity is high, so the rig will roll more easily in a curve
Legal weight does not make a load safe; height raises the center of gravity and it is height, not weight alone, that decides how readily the vehicle rolls over.
-
12. You have backed into the same loading bay every week for a year. How often should you still get out and walk to the rear before backing?
Show answer
Answer D: Every time, since the area can change while you are away from it
A familiar space is no guarantee; vehicles, pallets, people and overhead obstructions appear between one visit and the next, so you check on every occasion.
-
13. Why should the radio, the fan and other noisy equipment be switched off during a required stop at a railroad crossing?
Show answer
Answer C: So that an approaching train can be heard
The rules require the driver to look and listen along the track, and on a double track crossing a passing train can hide a second one, so hearing matters as much as seeing.
-
14. Taking your eyes off the road for about five seconds at highway speed means traveling roughly how far unseen?
Show answer
Answer A: About the length of a football field
At highway speed a five second glance away covers roughly 100 yards, which is far more road than any driver can afford to travel blind.
-
15. Which wheel or rim condition must be treated as a defect during the walkaround?
Show answer
Answer C: Cracks, illegal welded repairs, or missing and loose lug nuts
Cracked or welded rims and missing or loose fasteners can let a wheel separate from the vehicle and must be corrected before driving.
-
16. Your vehicle begins to hydroplane on a wet road. What should you do?
Show answer
Answer B: Release the accelerator and push in the clutch so the wheels can turn freely and regain grip
Hydroplaning tires are riding on water; slowing without braking lets them settle back onto the road and grip again.
-
17. What is axle weight?
Show answer
Answer C: The weight carried to the ground by one axle or one set of axles
Axle weight describes how the load is shared among the axles that carry it to the road, not how much the whole vehicle weighs.
-
18. Besides allowing the move at all, what does an oversize load permit usually set out?
Show answer
Answer C: The route to be followed, the hours of travel allowed and the warning equipment needed
Permits for oversize movements normally name the roads that may be used, restrict the times of travel, and list the flags, signs and escorts required.
-
19. What is wrong with resting your foot on the clutch pedal between shifts?
Show answer
Answer B: It slowly wears the clutch out, because the pressure plate is never fully engaged
Any weight on the pedal partly disengages the clutch, so it slips and wears; the foot belongs off the pedal once the shift is finished.
-
20. How often may a Virginia applicant take a CDL knowledge exam?
Show answer
Answer C: Once per business day
Virginia allows a CDL knowledge exam to be taken only once per business day.
-
21. An empty van trailer cleared a low overpass on the way in, but on the way back it is loaded. Which statement is true?
Show answer
Answer C: An empty van rides higher than a loaded one, so it needs more clearance than when loaded
Springs compress under load, so an empty trailer is taller; the unloaded trip is the one that can catch a low overhead.
-
22. How should the headlamps be checked during the pre-trip inspection?
Show answer
Answer A: By switching on both low beam and high beam and confirming each one works outside
Both beams are separate circuits, so each is switched on in turn and confirmed from outside the vehicle where the lamps can actually be seen.
-
23. You are hauling an open box of loose gravel. What does that load require?
Show answer
Answer A: A cover, so that material cannot blow off or spill onto the road
Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.
-
24. Under federal rules, what happens to a commercial driver found with any detectable amount of alcohol while operating a commercial vehicle?
Show answer
Answer D: The driver is placed out of service for 24 hours
Any measurable alcohol takes a commercial driver off the road for 24 hours, and a concentration of 0.04 percent or more brings a disqualification.
-
25. You drive a 40 foot straight truck at 50 miles per hour in good conditions. What following distance does the rule of thumb call for?
Show answer
Answer A: 5 seconds
One second for every 10 feet of vehicle length gives 4 seconds, and one extra second is added for speeds above 40 miles per hour.
-
26. What should you check about the air hoses and the electrical cord running to the trailer?
Show answer
Answer D: That they are free of damage, properly connected and not dragging or rubbing
Lines that chafe on the frame or drag on the road wear through, and a broken line takes away trailer braking or trailer lighting without warning.
-
27. What frame defects are you looking for during the walkaround?
Show answer
Answer A: Cracks, bends or broken cross members
The frame carries the whole load, so cracked or bent rails and broken cross members are serious structural defects.
-
28. Your load projects more than 4 feet beyond the rear of the vehicle. How must the projecting end be marked?
Show answer
Answer A: With a red or orange flag by day and a red lamp after dark
Federal rules require a warning flag on a rear projecting load in daylight and a red lamp on the end of it when lights are required.
-
29. You have stopped and a pedestrian is waiting to cross in front of your truck. Why should you not wave the person across?
Show answer
Answer C: Another driver may not stop, and your wave sends the person into danger
You cannot control what drivers in the other lanes will do, so you should not invite a pedestrian into a lane you do not command.
-
30. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
31. What does a front-end header board on a van or flatbed protect against?
Show answer
Answer A: Cargo moving forward toward the cab in a crash or hard stop
The header board, often called a headache rack, blocks forward movement of the load toward the driver.
-
32. On the Interstate System, what is the federal maximum weight allowed on a single axle?
Show answer
Answer A: 20,000 pounds
Federal limits for the Interstate System cap one single axle at 20,000 pounds.
-
33. When a helper guides you while backing, what should be agreed on before you start?
Show answer
Answer D: A set of hand signals, especially the signal that means stop
The driver and helper must agree on signals in advance, above all the stop signal, because they usually cannot hear each other.
-
34. How should the steering wheel be held when driving a large vehicle?
Show answer
Answer D: Firmly with both hands, placed on opposite sides of the wheel
Both hands on opposite sides give the leverage and control needed if a tire drops off the pavement or the wheel is jolted.
-
35. What happens when too much of the load sits over the steering axle?
Show answer
Answer D: The vehicle becomes hard to steer and the axle and its tires can be damaged
Weight beyond the front axle rating makes the steering heavy and can overload the axle and the tires carrying it.
-
36. Before raising the hood to inspect the engine compartment, what should you do?
Show answer
Answer B: Shut off the engine, set the parking brake and chock the wheels if needed
The engine compartment is inspected with the engine off and the vehicle secured so nothing can move or turn while your hands are inside.
-
37. What should a driver assume about the height posted at a bridge or an overpass?
Show answer
Answer B: That it may be wrong, because repaving or packed snow can leave less clearance than the sign shows
Resurfacing and packed snow raise the road under the structure, so the real clearance can be lower than the posted figure.
-
38. What is checked in step six of the seven-step method?
Show answer
Answer D: The turn signals and the stop lights, checked from outside the vehicle
Step six returns to the cab to switch on the signal and stop lamps, then checks each one from outside, because those lamps are not lit during the earlier light check.
-
39. Why must the driver of a large vehicle keep it centered in its lane?
Show answer
Answer B: The vehicle needs the full width of the lane
A commercial vehicle is close to lane width already, so any drift takes part of the vehicle into the next lane or onto the shoulder.
-
40. For a modern truck with low-friction parts and a streamlined shape, which gear should be used going down a grade?
Show answer
Answer D: A gear lower than the one needed to climb the same grade
Newer trucks roll more freely than older ones, so the old rule of using the climbing gear no longer holds; a lower gear is needed for enough engine braking.
-
41. Why should you never back under a trailer whose landing gear is resting on soft or muddy ground?
Show answer
Answer C: The landing gear can sink or collapse and the trailer can drop or tip over
Soft ground lets the landing gear sink under the load being transferred to it, and a trailer that drops or topples during coupling is extremely dangerous.
-
42. You are backing a tractor-trailer in a straight line and the trailer starts to drift to the left. What is the standard correction?
Show answer
Answer D: Turn the top of the steering wheel a little to the left, toward the drift
Small corrections made in the direction the trailer is drifting bring it back into line; large or opposite movements make the drift worse.
-
43. A chain rated at 6,600 pounds is fitted with a hook rated at 4,700 pounds. What is the working load limit of that assembly?
Show answer
Answer A: 4,700 pounds, the rating of the weakest part
An assembly is only as strong as its weakest component, so hooks, binders and links all count and the lowest rating governs.
-
44. Why must you never coast down a hill in neutral or with the clutch pushed in?
Show answer
Answer C: You lose the braking effect of the engine and your brakes may overheat and fail
Engine braking is what keeps a heavy vehicle in check on a grade; coasting throws it away and leaves the service brakes to do all the work until they overheat.
-
45. What does the driver check in the final step of the seven-step inspection?
Show answer
Answer A: Hydraulic brake leaks where those brakes are fitted, then the parking brake and the service brakes
The last step is done with the engine started: test for hydraulic leaks on vehicles with hydraulic brakes, then prove that the parking brake holds and that the service brakes stop the vehicle.
-
46. What is the correct way to test the parking brake before a trip?
Show answer
Answer C: With the parking brake set, put the vehicle in a low gear and gently try to move forward
A parking brake that holds against a gentle pull in low gear is working; if the vehicle moves, the brake needs adjustment or repair.
-
47. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
48. What is a bulkhead in a cargo body used for?
Show answer
Answer D: To divide the space and stop cargo from moving into another part of the body
A bulkhead is a solid partition that separates one part of the load space from another and blocks the cargo from moving past it.
-
49. A commercial vehicle stops on the shoulder of an undivided two-lane road that carries traffic in both directions. Where do the warning devices go?
Show answer
Answer B: Within 10 feet of the vehicle, plus 100 feet to the front and 100 feet to the rear
On a two-way road the devices must mark the vehicle itself and warn traffic approaching from each direction, and they must be in place within ten minutes.
-
50. Where are the OVERSIZE LOAD signs normally carried on a vehicle moving under such a permit?
Show answer
Answer A: On the front and the rear of the vehicle
The warning signs face the traffic that meets the load and the traffic that comes up behind it, so they go on the front and the rear.