Virginia DMV CDL General Knowledge Practice Test 8
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Why is driving much slower than the rest of the traffic dangerous?
Show answer
Answer B: Other drivers must keep passing you, which creates conflicts
Traffic that has to work its way around you produces lane changes and closing speeds, which is why a large speed difference is itself a hazard.
-
2. Before starting a trip, what must the driver confirm about the weight of the loaded vehicle?
Show answer
Answer A: That it is within the legal gross and axle limits for the route being driven
Overweight vehicles brake poorly, damage tires and suspension components, and can be put out of service at a scale, so weight is checked before the wheels turn.
-
3. Experienced commercial drivers scan the road ahead by roughly how much travel time?
Show answer
Answer B: About 12 to 15 seconds
Looking 12 to 15 seconds ahead gives a heavy vehicle enough room to slow or change lanes smoothly instead of reacting late.
-
4. Why should you never shift gears while crossing railroad tracks?
Show answer
Answer A: You could miss the gear or stall and be stuck on the tracks
A stalled or coasting vehicle on the tracks has no way to clear quickly, so choose the gear before the crossing and do not shift until you are across.
-
5. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
6. If an intersection has two lanes marked for left turns, which one should a large vehicle use?
Show answer
Answer D: The right hand of the two turning lanes
The outside turning lane leaves room for the rear of the vehicle to swing without striking a vehicle in the adjacent lane.
-
7. Why should you avoid using your lights to tell a following driver that it is safe to pass you?
Show answer
Answer B: You may misjudge the gap and the driver will act on your signal
The manual warns against signaling others to pass, because the responsibility for a head-on crash then rests on a judgment you could easily get wrong.
-
8. How long must a Virginia commercial learner's permit be held before the CDL skills test?
Show answer
Answer B: A minimum of 14 days
Virginia requires an applicant who has never held a CDL to obtain and hold a commercial learner's permit for a minimum of 14 days.
-
9. You are on a freeway and see brake lights come on in several vehicles far ahead of you. What should you do?
Show answer
Answer A: Ease off the accelerator and get ready to slow down
Brake lights well ahead are an early warning that traffic is slowing, and acting on them gives a heavy vehicle the room it needs.
-
10. How is the fluid level in an automatic transmission usually checked?
Show answer
Answer A: With the engine running, following the procedure in the operator manual
Most automatic transmissions are designed to be checked with the engine running, and the operator manual gives the exact conditions for that vehicle.
-
11. Where should a trailer be dropped, and what else does the driver do before pulling out from under it?
Show answer
Answer C: On solid level ground, with the trailer wheels chocked if it may roll
A dropped trailer must sit on ground that will carry the landing gear without sinking, and chocks stop it rolling once the tractor and its air supply are gone.
-
12. You are about to cross a long, high bridge with a light load in gusty wind. What should you do?
Show answer
Answer C: Slow down and be ready for a sudden push
Wind is strongest where a bridge leaves the shelter of the land, and lower speed gives you time to correct when the first gust hits.
-
13. When turning left, what should a driver of a long vehicle do before beginning the turn?
Show answer
Answer B: Reach the center of the intersection so the rear wheels clear the corner
The rear wheels follow a tighter path than the front, so the vehicle must reach the center of the intersection before the turn begins.
-
14. Which set of maneuvers makes up the basic control skills part of the commercial driving test?
Show answer
Answer D: Straight line backing, offset backing, parallel parking and alley docking
The basic control skills test is carried out off the road and consists of low speed exercises such as straight line backing, offset backing, parallel parking and the alley dock.
-
15. When traction is poor, such as on packed snow, how should you speed up?
Show answer
Answer C: Very gradually, so the drive wheels do not spin
Gentle throttle keeps the drive wheels from breaking traction, because spinning wheels give up both grip and directional control.
-
16. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.
-
17. An oncoming vehicle at night has bright headlights that are making it hard to see. What should you do?
Show answer
Answer B: Look toward the right edge of your lane and avoid looking directly at the lights
Looking at the right edge of the road keeps your eyes off the glare while you stay in your lane; glare can leave you nearly blind for several seconds.
-
18. Why should a driver avoid shifting gears in the middle of a turn at an intersection?
Show answer
Answer D: Shifting during the turn takes a hand off the wheel and can cost you control
Pick the gear before you begin turning; shifting in the turn removes a hand from the wheel and can interrupt power just when you need steady control.
-
19. You are stopped in traffic on a steep upgrade behind another truck. How much space should you leave in front?
Show answer
Answer A: Enough that you can pull away without rolling back into the vehicle behind you
Room ahead lets you get moving smoothly on a grade instead of having to hold the vehicle perfectly still or roll back toward the traffic behind.
-
20. The rear wheels of your vehicle lock during braking and the rear starts to slide sideways. What should you do first?
Show answer
Answer A: Stop braking so the rear wheels can roll again, then steer quickly in the direction you want to go
Locked wheels have no side grip; releasing the brakes restores traction and then countersteering brings the vehicle back into line.
-
21. An unblocked crate 4 feet long and weighing 1,500 pounds needs at least how many tiedowns?
Show answer
Answer A: Two
A short article that weighs more than 1,100 pounds requires at least two tiedowns even though it is under 5 feet long.
-
22. When should the horn of a commercial vehicle be used?
Show answer
Answer C: Only when it is needed to avoid a crash
An air horn is loud enough to startle other road users, so it is a warning device rather than a way to comment on other drivers.
-
23. How can a driver restart the 60 or 70 hour on-duty limit?
Show answer
Answer B: Take 34 or more consecutive hours off duty
A period of 34 or more consecutive hours off duty resets the 60 or 70 hour calculation so the driver can begin a new period.
-
24. You are about to slow down sharply on a highway to make a turn into a narrow driveway. How can you warn the drivers behind you?
Show answer
Answer C: Tap the brake pedal a few times so the brake lights flash before you slow down
A few light taps flash the brake lights and give following drivers an early warning that you are about to slow or stop.
-
25. Why should a driver avoid stopping partway up a snow covered hill?
Show answer
Answer D: You may not get moving again and could slide backwards
On a slippery grade the drive wheels may simply spin when you try to restart, leaving the vehicle stuck across the road or sliding back down it.
-
26. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
27. When must a driver first inspect the cargo and its securement devices?
Show answer
Answer C: Before starting the trip, as part of the pre-trip inspection
Cargo is part of the pre-trip inspection; the later checks within 50 miles and every three hours or 150 miles come on top of that first inspection.
-
28. On a scale, your loaded truck is well under the gross weight limit, but one axle is above the limit for that axle. What does this mean?
Show answer
Answer D: The vehicle is overloaded and the load must be shifted or reduced before you drive on
Each axle and axle group has its own limit and each must be respected; being under the gross limit does not excuse an overloaded axle.
-
29. You are asked to drive a truck loaded with enough hazardous materials to require placards. What must you have?
Show answer
Answer C: A hazardous materials endorsement on your commercial driver license
Driving a vehicle that must be placarded requires the H endorsement, which involves a separate knowledge test and a security background check.
-
30. With the tractor coupled to the trailer, what should you see between the upper and lower fifth wheel plates?
Show answer
Answer A: No space at all between the two plates
Any daylight between the plates means the trailer is not properly seated on the fifth wheel and the coupling can come apart under load.
-
31. An angry driver has cut in front of you and is now braking hard to provoke you. What is the safest response?
Show answer
Answer D: Drop back, avoid eye contact and let the driver go
Giving an aggressive driver space and no response removes the conflict, while any answering gesture invites escalation you cannot control in a heavy vehicle.
-
32. Why does a heavy vehicle need a much larger gap than a car in order to cross or enter traffic?
Show answer
Answer C: Because it accelerates slowly and needs far more road and time to clear the intersection
Slow acceleration combined with the length of the vehicle means a gap that would feel comfortable in a car is nowhere near enough.
-
33. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
34. Two vehicles of exactly the same length make a right turn, one gently and one very tightly. What is the effect on off-tracking?
Show answer
Answer A: Turning more sharply increases off-tracking, so the tight turn needs more room
Off-tracking depends on both the length of the vehicle and the sharpness of the turn; a tighter corner brings the rear wheels further inside the path of the front wheels.
-
35. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
36. What is the minimum tread depth for tires in positions other than the steering axle?
Show answer
Answer A: 2/32 inch
Drive and trailer tires must keep at least 2/32 inch of tread in a major groove, measured away from tie bars and fillets.
-
37. During a right turn in a tractor-trailer, what are you looking for in the right hand mirror?
Show answer
Answer B: Whether the trailer will clear the curb and whether anything has moved alongside you
The right mirror is what tells you how close the trailer wheels are running to the curb and whether a vehicle or a cyclist has slipped into the space on your right.
-
38. What is the purpose of the torque rods or radius rods you check on the suspension?
Show answer
Answer A: They hold the axle in alignment with the frame under braking and acceleration
Torque rods resist the twisting and fore and aft forces on the axle, so a cracked or missing rod lets the axle move out of alignment.
-
39. How does a typical escape ramp stop a runaway vehicle?
Show answer
Answer B: With a bed of loose gravel or sand, often on an upgrade
Escape ramps use deep loose material, usually combined with a rising grade, so the vehicle is slowed gradually instead of being stopped by impact.
-
40. Cargo securement must be strong enough to hold the load under which conditions?
Show answer
Answer A: Hard braking, hard acceleration and hard turning, as well as the bouncing of the road
The securement standard is written around the forces of a hard stop, a hard start, a hard turn and vertical movement on a rough surface, all of which occur in ordinary driving.
-
41. You find a defect during the pre-trip inspection. What must happen before the vehicle is driven?
Show answer
Answer C: It must be repaired, or the vehicle must not be driven
Writing a defect down does not make the vehicle safe; a defect that affects safe operation has to be corrected before the trip starts.
-
42. When should a lower gear be selected for a long downgrade?
Show answer
Answer D: Before you start down the hill
The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.
-
43. When is tire pressure most accurately compared with the recommended figure?
Show answer
Answer B: When the tires are cold, before the vehicle has been driven
Recommended pressures are cold pressures, so a reading taken before the tires have heated up is the only one that can be compared directly.
-
44. What is generally the safest speed in dense but freely moving highway traffic?
Show answer
Answer D: The speed of the traffic around you, up to the posted limit
Crashes rise with the difference between your speed and the traffic around you, so moving with the flow within the legal limit is safest.
-
45. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
46. Why should a retarder be switched off when the road is wet, icy or snowy?
Show answer
Answer C: It can make the drive wheels skid when traction is poor
A retarder slows the drive wheels only, and on a slippery surface that braking force can break their traction and start a skid.
-
47. Why is it harder to judge speed and distance at night?
Show answer
Answer C: You see much less detail and have fewer reference points
Darkness removes the visual references that the brain uses to estimate distance and closing speed, so drivers routinely misjudge both.
-
48. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.
-
49. Which of these counts as a serious traffic violation for a commercial driver license holder?
Show answer
Answer C: Speeding 15 miles per hour or more above the limit
Excessive speeding, reckless driving, improper lane changes, following too closely and texting while driving are all serious traffic violations.
-
50. You are drifting in the lane, yawning constantly and cannot remember the last few miles. What is the only reliable cure?
Show answer
Answer C: Stopping in a safe place and sleeping
Those are classic drowsiness warning signs, and nothing except sleep repays the sleep the body is missing.